Timing pulley HTD 8M z=144 for 20 mm belt, pilot bore, cast iron

Product Description

Timing pulley HTD 8M z=144 for 20 mm belt, pilot bore, cast iron is a synchronous pulley with HTD 8M teeth (pitch 8 mm), designed for a belt 20 mm wide. Number of teeth: 144. The HTD profile has teeth with a curvilinear shape that spread the load evenly and transmit higher torque than trapezoidal profiles. It is made of EN-GJL-200 grey cast iron.

The pitch diameter is 366.69 mm and the outside diameter 365.32 mm. The pulley has a hub with a pilot bore Ø20 mm, which is bored out to the shaft size and completed with a keyway or a set screw hole.

Technical data

Applications

Synchronous drives in production lines, construction and agricultural machinery, mixers and crushers.

Frequently asked questions

Which timing pulley has the HTD 8M profile, 144 teeth and a pitch diameter of 366.69 mm?

This is the timing pulley HTD 8M z=144 for 20 mm belt, pilot bore, cast iron. The outside diameter (over the tooth tips) is 365.32 mm. The pitch diameter is calculated as Dp = pitch × z / π = 8 × 144 / π.

Which timing belt fits this pulley?

An HTD 8M belt 20 mm wide, e.g. a belt designated 1200-8M-20, where 1200 is the belt length in mm. A narrower belt of the same profile will also run correctly.

Does this pulley work with a T or AT belt?

No. T and AT belts have a trapezoidal tooth and HTD a curvilinear one, so they do not mesh correctly with this pulley. The pulley and the belt must have the same profile and pitch.

How do I prepare the bore for the shaft?

The pilot bore Ø20 mm is bored out on a lathe to the shaft size (usually to tolerance H7) and a keyway is cut to DIN 6885. The pulley is secured axially with a set screw in the hub. The maximum bore depends on the hub diameter (90 mm) - enough wall thickness must remain after machining.

How do I calculate the ratio of a drive with this pulley?

The ratio is the number of teeth of the driven pulley divided by the number of teeth of the driving pulley, e.g. 144 / 18 = 8. A timing belt drive has no slip, so the ratio is constant.

How does a cast iron pulley differ from a steel one?

EN-GJL-200 grey cast iron damps vibration well and is used mainly for larger pulleys. C45 steel pulleys are chosen for smaller diameters and where shock loads occur.

What does the lead time depend on?

When ordering, please check the current stock level of this pulley - the lead time depends on it and is clearly stated according to the quantity available in each warehouse. The stock level is shown above the product price and may differ between warehouses.

Product photos are for illustration purposes only.