Timing pulley T5 z=10 for 25 mm belt, pilot bore, aluminium

Product Description

Timing pulley T5 z=10 for 25 mm belt, pilot bore, aluminium works with T5 timing belts with a pitch of 5 mm and a width of 25 mm. The pulley has 10 teeth. The T profile has a trapezoidal tooth to DIN 7721 and is widely used in drives and linear axes. It is made of 6082 T6 aluminium, which makes it light and gives it low inertia.

The pitch diameter is 15.92 mm and the outside diameter 15.05 mm. The pulley has a hub with a pilot bore Ø4 mm, which is bored out to the shaft size and completed with a keyway or a set screw hole. The flanges (Ø19.5 mm) guide the belt and stop it running off the pulley.

Technical data

Applications

Linear axes, 3D printers, plotters, measuring equipment, small automation drives and office equipment.

Frequently asked questions

Which timing pulley has the T5 profile, 10 teeth and a pitch diameter of 15.92 mm?

This is the timing pulley T5 z=10 for 25 mm belt, pilot bore, aluminium. The outside diameter (over the tooth tips) is 15.05 mm. The pitch diameter is calculated as Dp = pitch × z / π = 5 × 10 / π.

Which timing belt fits this pulley?

A T5 belt 25 mm wide, e.g. belt 25 T5/450, where 450 is the belt length in mm. Both endless and open (by the metre) belts of this profile fit.

Does this pulley work with an AT or HTD belt?

No. An AT belt of the same pitch has a larger tooth and does not fit the grooves of a T pulley, and an HTD belt has a curvilinear tooth. The pulley and the belt must have the same profile and pitch.

How do I prepare the bore for the shaft?

The pilot bore Ø4 mm is bored out on a lathe to the shaft size (usually to tolerance H7) and a keyway is cut to DIN 6885. The pulley is secured axially with a set screw in the hub. The maximum bore depends on the hub diameter (8 mm) - enough wall thickness must remain after machining.

How do I calculate the ratio of a drive with this pulley?

The ratio is the number of teeth of the driven pulley divided by the number of teeth of the driving pulley, e.g. 10 / 20 = 0.5. A timing belt drive has no slip, so the ratio is constant.

What are the flanges for?

The flanges guide the belt and prevent it from running off the pulley. In a typical drive it is enough for one of the two pulleys, usually the smaller one, to have flanges.

What drives is an aluminium pulley suitable for?

For light and moderately loaded drives where low weight and inertia matter, e.g. in automation, positioning equipment and packaging machines. 6082 T6 aluminium does not rust and can be anodised.

What does the lead time depend on?

When ordering, please check the current stock level of this pulley - the lead time depends on it and is clearly stated according to the quantity available in each warehouse. The stock level is shown above the product price and may differ between warehouses.

Product photos are for illustration purposes only.