Sprocket 32B-3 z=50 with hub

Product Description

Sprocket 32B-3 z=50, with hub

Sprocket 32B-3 with hub, 50 teeth, triplex (three-strand) - a product matched to chain with a pitch of 50.8 mm (2"). Compliance with DIN 8187 / ISO 606 guarantees full interchangeability with a chain of the same pitch; the sprocket is made of C45E steel (EN 10083-1) in a non-hardened version - the standard choice for applications with moderate and medium load.

Technical data

Frequently asked questions

How can a sprocket and chain be protected against corrosion during storage?

After cleaning off any dirt, it is advisable to apply a layer of preservative grease or anti-corrosion oil and store the sprocket in a dry place not exposed to condensation. In the steel version (without coating), even a short damp break in the workshop can cause a rusty film on the tooth surfaces.

Does a larger number of teeth always mean a longer service life for the sprocket?

Largely yes - the more teeth are engaged, the lower the load on each individual tooth, and the chain runs over a larger wrap angle, which reduces dynamic impacts. Very small sprockets (with fewer than fifteen or so teeth) wear the fastest and are best avoided if the drive design allows.

What happens when a sprocket operates under a greater load than intended?

Overloading first accelerates normal tooth wear, and with sudden overloads (e.g. machine blockage) the teeth may become permanently bent or sheared. In such cases, using an overload clutch in the system is often a better solution than choosing an oversized sprocket "just in case".

How do I bore the hole in a sprocket to fit a motor shaft?

A sprocket with a pilot bore should be clamped in a lathe (gripping the hub to avoid runout) and bored to the required diameter with an H7 tolerance. The hub is usually soft and easy to machine, even in the version with hardened teeth.

Where is this product used?

32B-3 sprockets are used in industrial drive transmissions: conveyors, feeders, packaging machines and production lines where precise, repeatable torque transmission matters.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.