Sprocket 32B-3 z=15 with hub

Product Description

Sprocket 32B-3 z=15, with hub

Sprocket 32B-3 (pitch 2" - 50.8 mm), triplex (three-strand), 15 teeth, with hub. The material is C45E carbon steel (EN 10083-1), and the teeth remain unhardened (without induction hardening) - in accordance with DIN 8187 / ISO 606; this version is easier to machine over the entire depth of the sprocket.

Technical data

Frequently asked questions

How do I determine the centre distance between the driving and driven sprockets?

The centre distance should provide an adequate chain wrap angle on the smaller sprocket (usually a minimum of about 120°) and sufficient chain length so that the number of links is a whole number, preferably even. Too small a centre distance increases the meshing frequency and accelerates wear, while too large a one leads to excessive chain sag.

Do a newly fitted chain and sprocket require running-in after installation?

After installation, it is worth running the drive for a while without full load, observing the smoothness of operation and the bearing temperature - this allows installation errors (e.g. misalignment) to be detected before full load is applied. The tooth profile of the sprocket itself does not require running-in if the sprocket and chain have matching pitch and are made in accordance with the standard.

Can a sprocket with a technological bore be installed without additional machining?

No - the technological bore is deliberately too small to fit a typical shaft. It must be bored on a lathe to the required diameter and, if necessary, a keyway cut according to the requirements of the specific machine.

How do I check the radial and axial runout of a sprocket after mounting it on the shaft?

A dial indicator on a magnetic stand is used for the measurement. Place the tip against the circumference of the sprocket or its side face, rotate the shaft and check the deviations. Excessive runout indicates faulty installation or a damaged shaft.

Where is this product used?

Typical applications of the 32B-3 sprocket: drives for pumps, mixers and industrial fans, as well as control systems for industrial gates and roller shutters, where resistance to continuous operation is required.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.