Sprocket 28B-3 z=23 with hub

Product Description

Sprocket 28B-3 z=23, with hub

Sprocket 28B-3 with hub, 23 teeth, triplex (three-strand) - a product matched to chain with a pitch of 44.45 mm (1 3/4"). Manufactured in accordance with DIN 8187 / ISO 606 from C45E structural steel (EN 10083-1), without tooth hardening - as a Polish manufacturer, Ozdowski supplies an economical version that is fully dimensionally interchangeable with the hardened variant of the same pitch.

Technical data

Frequently asked questions

What does uneven, one-sided wear of the sprocket teeth indicate?

This usually indicates misalignment between the driving and driven sprockets or that the chain is skewed relative to the sprocket. It is worth checking the alignment of both sprockets and the condition of the shaft bearings - over time, one-sided wear causes the chain to jump off the tooth.

How can you recognise a sprocket not made in accordance with the DIN 8187 profile?

Most often it is visible from the incorrect seating of the chain on the teeth - the chain "sits" on the tooth tips or too deep in the tooth roots, despite the correct pitch. In that case, it is worth placing a section of a known reference chain of this pitch on the sprocket and checking whether it engages each tooth evenly and smoothly.

Why are cast sprockets less precise than turned and milled ones?

Cheap castings have a rough tooth surface, hidden air bubbles and slight deformations. CNC-turned and milled sprockets mean a smooth working surface, perfect alignment and safety for the most expensive machines.

Can a sprocket be welded directly to the drive shaft?

Technically this is possible, but we strongly advise against such a solution. Welding overheats the material, damages nearby bearings, bends the shaft and prevents the worn sprocket from being easily replaced later. Always use mounting with a key or a clamping bush.

Where is this product used?

Typical applications of the 28B-3 sprocket: drives for pumps, mixers and industrial fans, as well as control systems for industrial gates and roller shutters, where resistance to continuous operation is required.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.