Sprocket 28B-3 z=20 with hub

Product Description

Sprocket 28B-3 z=20, with hub

Sprocket 28B-3 with hub, 20 teeth, triplex (three-strand) - a product matched to chain with a pitch of 44.45 mm (1 3/4"). The material is C45E carbon steel (EN 10083-1), and the teeth remain unhardened (without induction hardening) - in accordance with DIN 8187 / ISO 606; this version is easier to machine over the entire depth of the sprocket.

Technical data

Frequently asked questions

What does uneven, one-sided wear of the sprocket teeth indicate?

This usually indicates misalignment between the driving and driven sprockets or that the chain is skewed relative to the sprocket. It is worth checking the alignment of both sprockets and the condition of the shaft bearings - over time, one-sided wear causes the chain to jump off the tooth.

When ordering several sprockets for one drive, do they have identical production parameters?

Sprockets of the same catalogue item are produced according to the same documentation and tolerances, so their parameters (pitch, number of teeth, dimensions) match each other regardless of when they were ordered. Any slight differences in the shade of the steel between production batches have no effect on how the sprocket works with the chain.

How do I select a sprocket with bearing for a tensioning system?

An idler sprocket (with built-in bearing) is selected according to the pitch of the working chain and mounted on the slack side (not on the tight side). It is important that the bearing is protected against dust, especially in agricultural machinery.

How do I determine the centre distance between the driving and driven sprockets?

The centre distance should provide an adequate chain wrap angle on the smaller sprocket (usually a minimum of about 120°) and sufficient chain length so that the number of links is a whole number, preferably even. Too small a centre distance increases the meshing frequency and accelerates wear, while too large a one leads to excessive chain sag.

Where is this product used?

Applications include drives in the food industry, packaging machines, sorting lines and agricultural harvesting machines, where the sprocket operates seasonally but under full load.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.