Sprocket 28B-1 z=19 with hub

Product Description

Sprocket 28B-1 z=19, with hub

Sprocket 28B-1 (pitch 1 3/4" - 44.45 mm), simplex, 19 teeth, with hub. As a European manufacturer, Ozdowski supplies the sprocket in C45E steel (EN 10083-1), in accordance with DIN 8187 / ISO 606 - a version without tooth hardening, cheaper than the hardened variant and sufficient for many typical industrial applications.

Technical data

Frequently asked questions

How do sprockets for roller chains differ from sprockets for toothed chains (silent chain)?

A sprocket for roller chain has a rounded tooth root matched to the chain roller (profile according to DIN 8187), whereas a sprocket for toothed chain (silent chain) has a flat, trapezoidal tooth profile that engages the chain plates instead of rollers. These two systems are not interchangeable.

What does uneven, one-sided wear of the sprocket teeth indicate?

This usually indicates misalignment between the driving and driven sprockets or that the chain is skewed relative to the sprocket. It is worth checking the alignment of both sprockets and the condition of the shaft bearings - over time, one-sided wear causes the chain to jump off the tooth.

What is the relationship between the number of teeth of a sprocket and the rotational speed of the drive?

This is the basic principle of the transmission ratio. If there is a small sprocket on the motor (drive) and a large one on the machine, the machine will turn more slowly but gain proportionally greater torque (force).

How can you recognise a sprocket not made in accordance with the DIN 8187 profile?

Most often it is visible from the incorrect seating of the chain on the teeth - the chain "sits" on the tooth tips or too deep in the tooth roots, despite the correct pitch. In that case, it is worth placing a section of a known reference chain of this pitch on the sprocket and checking whether it engages each tooth evenly and smoothly.

Where is this product used?

Typical applications of the 28B-1 sprocket: drives for pumps, mixers and industrial fans, as well as control systems for industrial gates and roller shutters, where resistance to continuous operation is required.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.