Sprocket 24B-3 z=76 with hub

Product Description

Sprocket 24B-3 z=76, with hub

The sprocket 24B-3 shown is a triplex (three-strand) sprocket with 76 teeth, made with a hub, for chain with a pitch of 1 1/2" / 38.1 mm. The sprocket complies with DIN 8187 / ISO 606 and is made of C45E steel (EN 10083-1); the teeth are not hardened, which lowers the cost of the sprocket and makes it easier to machine (e.g. deep boring of the hub) throughout the entire volume of the material.

Technical data

Frequently asked questions

Does a larger number of teeth always mean a longer service life for the sprocket?

Largely yes - the more teeth are engaged, the lower the load on each individual tooth, and the chain runs over a larger wrap angle, which reduces dynamic impacts. Very small sprockets (with fewer than fifteen or so teeth) wear the fastest and are best avoided if the drive design allows.

What does the pitch of a sprocket mean and how can it be checked?

The pitch of a sprocket corresponds to the chain pitch - it is the theoretical distance between the centres of adjacent teeth on the pitch circle. The easiest way to check it is to place a section of matching chain on the sprocket - it should sit perfectly, without tension.

How should a chain drive be lubricated to extend its service life?

The lubricant should get between the rollers and plates of the chain, not just onto its outer surface - it is best applied to the lower (slack) part of the chain, just before it runs onto the sprocket. In a dusty environment, a thick grease works better, while at high speeds a lower-viscosity oil that penetrates the joints more easily is preferable.

Do a newly fitted chain and sprocket require running-in after installation?

After installation, it is worth running the drive for a while without full load, observing the smoothness of operation and the bearing temperature - this allows installation errors (e.g. misalignment) to be detected before full load is applied. The tooth profile of the sprocket itself does not require running-in if the sprocket and chain have matching pitch and are made in accordance with the standard.

Where is this product used?

Typical applications of the 24B-3 sprocket: drives for pumps, mixers and industrial fans, as well as control systems for industrial gates and roller shutters, where resistance to continuous operation is required.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.