Sprocket 24B-3 z=26 with hub

Product Description

Sprocket 24B-3 z=26, with hub

Sprocket 24B-3 (pitch 1 1/2" - 38.1 mm), triplex (three-strand), 26 teeth, with hub. Manufactured in accordance with DIN 8187 / ISO 606 from C45E structural steel (EN 10083-1), without tooth hardening - as a Polish manufacturer, Ozdowski supplies an economical version that is fully dimensionally interchangeable with the hardened variant of the same pitch.

Technical data

Frequently asked questions

How do you calculate the pitch circle diameter of a sprocket?

The pitch circle diameter (Dp) is, in simplified terms, the line along which the chain rollers roll. It is calculated using the formula: pitch divided by sine (180° / number of teeth).

Can material documentation (certificate) for the sprocket be included with the order?

Material documentation is not sent automatically with standard catalogue orders, but if it is needed (e.g. for the machine's technical documentation), please notify the sales department when placing the order.

How do I determine the centre distance between the driving and driven sprockets?

The centre distance should provide an adequate chain wrap angle on the smaller sprocket (usually a minimum of about 120°) and sufficient chain length so that the number of links is a whole number, preferably even. Too small a centre distance increases the meshing frequency and accelerates wear, while too large a one leads to excessive chain sag.

What does uneven, one-sided wear of the sprocket teeth indicate?

This usually indicates misalignment between the driving and driven sprockets or that the chain is skewed relative to the sprocket. It is worth checking the alignment of both sprockets and the condition of the shaft bearings - over time, one-sided wear causes the chain to jump off the tooth.

Where is this product used?

24B-3 sprockets are used in industrial drive transmissions: conveyors, feeders, packaging machines and production lines where precise, repeatable torque transmission matters.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.