Sprocket 24B-1 z=24 with hub

Product Description

Sprocket 24B-1 z=24, with hub

Sprocket 24B-1 (pitch 1 1/2" - 38.1 mm), simplex, 24 teeth, with hub. Compliance with DIN 8187 / ISO 606 guarantees full interchangeability with a chain of the same pitch; the sprocket is made of C45E steel (EN 10083-1) in a non-hardened version - the standard choice for applications with moderate and medium load.

Technical data

Frequently asked questions

How do you cut a keyway in the hub of a sprocket?

We cut keyways precisely on slotting machines according to DIN 6885. If you do it yourself, maintain axial alignment and the correct width and depth of the keyway so that the key sits securely and is not sheared off.

Does a sprocket with hub have a fixed mounting side, or can it be reversed?

The sprocket is usually symmetrical with respect to the plane of the rim, so the rim itself cannot be "reversed incorrectly" - but the hub is usually on only one side of the sprocket, which determines which way the sprocket must be mounted relative to other components on the shaft (e.g. bearings, other sprockets).

How often should chain tension be checked on a machine in operation?

In machines operating continuously, it is advisable to check the tension every few weeks, and in a newly installed drive - as early as after the first hours of operation, when the chain "beds in". A correctly tensioned chain has a slight, visible sag on the slack side - too tight a chain accelerates bearing wear, while too loose a chain increases the risk of it jumping off the sprocket.

Does the difference in hardness between sprocket and chain affect their rate of wear?

Yes - chain and sprocket manufacturers select hardness so that they wear as evenly as possible, rather than one element "cutting down" the other. An excessively hard sprocket working with a soft, non-certified chain (or vice versa) leads to faster wear of the weaker element.

Where is this product used?

Typical applications of the 24B-1 sprocket: drives for pumps, mixers and industrial fans, as well as control systems for industrial gates and roller shutters, where resistance to continuous operation is required.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.