Sprocket 20B-3 z=11 with hub

Product Description

Sprocket 20B-3 z=11, with hub

The sprocket 20B-3 shown is a triplex (three-strand) sprocket with 11 teeth, made with a hub, for chain with a pitch of 1 1/4" / 31.75 mm. As a European manufacturer, Ozdowski supplies the sprocket in C45E steel (EN 10083-1), in accordance with DIN 8187 / ISO 606 - a version without tooth hardening, cheaper than the hardened variant and sufficient for many typical industrial applications.

Technical data

Frequently asked questions

How does a sprocket with hardened teeth differ from the standard version (non-hardened)?

The hardened version has teeth induction-hardened to 45-55 HRC, which extends service life in drives operating continuously and under heavy load. The standard version (non-hardened) is cheaper and fully adequate for applications with moderate load or intermittent operation - our catalogue offers both variants for most pitches and numbers of teeth.

How do I determine the centre distance between the driving and driven sprockets?

The centre distance should provide an adequate chain wrap angle on the smaller sprocket (usually a minimum of about 120°) and sufficient chain length so that the number of links is a whole number, preferably even. Too small a centre distance increases the meshing frequency and accelerates wear, while too large a one leads to excessive chain sag.

What should be used to preserve sprockets before a longer break in operation?

After cleaning with a brush and a technical cleaner, apply preservative grease or a thick, moisture-displacing spray oil to the entire surface of the sprocket. This will protect the metal against rust deposits during the break while it is stored in the hall.

When is it worth using a clamping bush (Taper Bush) for a sprocket?

Wherever fast assembly matters. A clamping bush eliminates the need for laborious boring of the hub and cutting of a keyway - you insert the sprocket, tighten the screws and the machine is back in operation within minutes.

Where is this product used?

This type of sprocket is used in drives of agricultural and industrial machinery, including screw and bucket conveyors, feed conveyors, packaging machines and internal transport systems.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.