Sprocket 20B-2 z=35 with hub, hardened

Product Description

Sprocket 20B-2 z=35, hardened hub

Sprocket 20B-2, duplex, with 35 teeth and a hardened hub - pitch 1 1/4" (31.75 mm). The material is carbon steel C45E (EN 10083-1), and the teeth undergo induction hardening to 45-55 HRC - in accordance with DIN 8187 / ISO 606; the hub retains a lower core hardness, so it can be machined safely.

Technical data

Frequently asked questions

What causes premature wear of the side faces of the teeth?

This is most often the result of misalignment of the sprockets on the shafts (so-called lateral runout of the drive). The chain does not run straight, and its inner plates catch on the sides of the teeth, wearing them down to bare metal. The system must be realigned immediately.

What should be used to preserve sprockets before a longer break in operation?

After cleaning with a brush and a technical cleaner, apply preservative grease or a thick, moisture-displacing spray oil to the entire surface of the sprocket. This will protect the carbon steel against a rusty film during a break in the workshop.

How does uneven tooth wear affect machine vibration?

Worn teeth cause the so-called polygon effect - the chain drops off and climbs onto the teeth abruptly, which transmits vibrations to the shafts, destroys the bearings and leads to cracking of welds in the machine.

Is a duplex sprocket the same as a tandem sprocket (for two single chains)?

No, even though they look very similar. A tandem sprocket is also a single, monolithic sprocket, but with a different (wider) spacing of the toothed rims - designed specifically for two independent simplex chains running in parallel. This duplex sprocket has a rim spacing matched to a single duplex chain, in which both strands are integrated with each other. Using a duplex sprocket for two single chains is a mistake - the spacing is too narrow and the chains will rub against each other, which leads to accelerated wear and, in extreme cases, to serious drive failure.

Where is this product used?

20B-2 sprockets operate in the drives of construction machinery, goods lifts, aggregate conveyors and woodworking machines - wherever tooth durability under heavy load matters.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.