Sprocket 20B-2 z=25 with hub, hardened

Product Description

Sprocket 20B-2 z=25, hardened hub

The sprocket 20B-2 shown is a duplex sprocket with 25 teeth, made with a hardened hub, for chain with a pitch of 1 1/4" / 31.75 mm. Compliance with DIN 8187 / ISO 606 guarantees full interchangeability with chain of the same pitch; C45E steel (EN 10083-1) and induction hardening of the teeth (45-55 HRC) provide high wear resistance while keeping the hub machinable.

Technical data

Frequently asked questions

In what cases are multi-strand sprockets used?

They are used to drive multi-strand chains in heavily loaded machines where there is no room for a wider sprocket with a larger pitch. Several strands distribute the load evenly, preventing premature chain breakage.

What material is this sprocket made of?

As standard, it is carbon steel C45E (EN 10083-1) - a good material for typical industrial applications, providing a good balance between strength and machinability of the hub.

What forces act on the key in a sprocket and how can it be prevented from shearing?

The key transmits the entire shearing torque between the shaft and the sprocket. Make sure it is made of suitable quenched and tempered steel, has an accurate fit in the keyway and that the machine is not subjected to extreme jerks without an overload clutch.

Is a duplex sprocket the same as a tandem sprocket (for two single chains)?

No, even though they look very similar. A tandem sprocket is also a single, monolithic sprocket, but with a different (wider) spacing of the toothed rims - designed specifically for two independent simplex chains running in parallel. This duplex sprocket has a rim spacing matched to a single duplex chain, in which both strands are integrated with each other. Using a duplex sprocket for two single chains is a mistake - the spacing is too narrow and the chains will rub against each other, which leads to accelerated wear and, in extreme cases, to serious drive failure.

Where is this product used?

This type of sprocket is used in drives of agricultural and industrial machinery, including screw and bucket conveyors, feed conveyors, packaging machines and internal transport systems.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.