Sprocket 20B-2 z=20 with hub, hardened

Product Description

Sprocket 20B-2 z=20, hardened hub

Sprocket 20B-2 with hardened hub, 20 teeth, duplex - a product matched to chain with a pitch of 31.75 mm (1 1/4"). The material is carbon steel C45E (EN 10083-1), and the teeth undergo induction hardening to 45-55 HRC - in accordance with DIN 8187 / ISO 606; the hub retains a lower core hardness, so it can be machined safely.

Technical data

Frequently asked questions

How does a hardness of around 45-55 HRC on the teeth extend the service life of the sprocket-chain system?

A hardness of 45-55 HRC matched to the hardened chain rollers is the optimal combination. The sprocket and chain wear slowly and evenly, and the sprocket does not turn into a "blade" that could shear the chain during operation.

When is it worth considering a sprocket made of reinforced steel for heavy-duty operating conditions?

In heavy dust, with powerful jolts (e.g. in presses) and where a breakdown in the middle of the season cannot be afforded, sprockets made of higher-strength quenched and tempered steel are often a good solution - it is worth consulting the supplier about unusual operating conditions.

What causes premature wear of the side faces of the teeth?

This is most often the result of misalignment of the sprockets on the shafts (so-called lateral runout of the drive). The chain does not run straight, and its inner plates catch on the sides of the teeth, wearing them down to bare metal. The system must be realigned immediately.

Is a duplex sprocket the same as a tandem sprocket (for two single chains)?

No, even though they look very similar. A tandem sprocket is also a single, monolithic sprocket, but with a different (wider) spacing of the toothed rims - designed specifically for two independent simplex chains running in parallel. This duplex sprocket has a rim spacing matched to a single duplex chain, in which both strands are integrated with each other. Using a duplex sprocket for two single chains is a mistake - the spacing is too narrow and the chains will rub against each other, which leads to accelerated wear and, in extreme cases, to serious drive failure.

Where is this product used?

Typical applications of the 20B-2 sprocket: drives for pumps, mixers and industrial fans, as well as control systems for industrial gates and roller shutters, where resistance to continuous operation is required.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.