Sprocket 20B-2 z=16 with hub, hardened

Product Description

Sprocket 20B-2 z=16, hardened hub

The sprocket 20B-2 shown is a duplex sprocket with 16 teeth, made with a hardened hub, for chain with a pitch of 1 1/4" / 31.75 mm. Sprocket compliant with DIN 8187 / ISO 606, milled from C45E steel (EN 10083-1); the teeth are induction hardened (45-55 HRC), while the core and hub remain soft, allowing the bore to be safely machined to the shaft size.

Technical data

Frequently asked questions

How do you cut a keyway in the hub of a sprocket?

We cut keyways precisely on slotting machines according to DIN 6885. If you do it yourself, maintain axial alignment and the correct width and depth of the keyway so that the key sits securely and is not sheared off.

Why are cast sprockets less precise than turned and milled ones?

Cheap castings have a rough tooth surface, hidden air bubbles and slight deformations. CNC-turned and milled sprockets mean a smooth working surface, perfect alignment and safety for the most expensive machines.

What material is this sprocket made of?

As standard, it is carbon steel C45E (EN 10083-1) - a good material for typical industrial applications, providing a good balance between strength and machinability of the hub.

Is a duplex sprocket the same as a tandem sprocket (for two single chains)?

No, even though they look very similar. A tandem sprocket is also a single, monolithic sprocket, but with a different (wider) spacing of the toothed rims - designed specifically for two independent simplex chains running in parallel. This duplex sprocket has a rim spacing matched to a single duplex chain, in which both strands are integrated with each other. Using a duplex sprocket for two single chains is a mistake - the spacing is too narrow and the chains will rub against each other, which leads to accelerated wear and, in extreme cases, to serious drive failure.

Where is this product used?

Typical applications of the 20B-2 sprocket: drives for pumps, mixers and industrial fans, as well as control systems for industrial gates and roller shutters, where resistance to continuous operation is required.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.