Sprocket 20B-1 z=34 with hub

Product Description

Sprocket 20B-1 z=34, with hub

Sprocket 20B-1 with hub, 34 teeth, simplex - a product matched to chain with a pitch of 31.75 mm (1 1/4"). The sprocket complies with DIN 8187 / ISO 606 and is made of C45E steel (EN 10083-1); the teeth are not hardened, which lowers the cost of the sprocket and makes it easier to machine (e.g. deep boring of the hub) throughout the entire volume of the material.

Technical data

Frequently asked questions

How does rotational speed affect the selection of the minimum number of teeth of a sprocket in the system?

At higher rotational speeds, a larger minimum number of teeth on the smallest sprocket in the system is recommended to reduce chain vibration and impacts resulting from the so-called polygon effect. With very small sprockets (e.g. 9-11 teeth) and high speeds, wear and vibration levels increase significantly faster than with larger sprockets.

What happens when a sprocket operates under a greater load than intended?

Overloading first accelerates normal tooth wear, and with sudden overloads (e.g. machine blockage) the teeth may become permanently bent or sheared. In such cases, using an overload clutch in the system is often a better solution than choosing an oversized sprocket "just in case".

How can you tell whether a sprocket is still fit for further service or already due for replacement?

It is worth checking the tooth profile for visible chipping or the characteristic "hooked" shape, and also measuring the pitch circle diameter and comparing it with the catalogue dimension of a new sprocket. If the difference is visually noticeable or the chain starts to "jump", the sprocket is due for replacement.

How can you check that the sprocket meshes correctly with the chain when the machine is started for the first time?

At low speed (e.g. turning the shaft by hand), it is worth observing whether the chain enters and leaves the teeth smoothly around the entire circumference of the sprocket, without catching or jumping. Any irregularities in operation at this stage usually indicate an alignment error rather than a defect in the sprocket itself.

Where is this product used?

20B-1 sprockets are used in industrial drive transmissions: conveyors, feeders, packaging machines and production lines where precise, repeatable torque transmission matters.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.