Sprocket 20B-1 z=11 with hub

Product Description

Sprocket 20B-1 z=11, with hub

Sprocket 20B-1, simplex, with 11 teeth and a hub - pitch 1 1/4" (31.75 mm). The sprocket complies with DIN 8187 / ISO 606 and is made of C45E steel (EN 10083-1); the teeth are not hardened, which lowers the cost of the sprocket and makes it easier to machine (e.g. deep boring of the hub) throughout the entire volume of the material.

Technical data

Frequently asked questions

How can you check that the sprocket meshes correctly with the chain when the machine is started for the first time?

At low speed (e.g. turning the shaft by hand), it is worth observing whether the chain enters and leaves the teeth smoothly around the entire circumference of the sprocket, without catching or jumping. Any irregularities in operation at this stage usually indicate an alignment error rather than a defect in the sprocket itself.

How does the choice of the number of teeth affect vibration levels and drive operation?

A smaller number of teeth means fewer meshing points per revolution and larger fluctuations in the instantaneous chain speed (the so-called polygon effect), which results in higher vibration levels. Increasing the number of teeth of the sprocket (at the same pitch) smooths the operation of the drive, although it increases its overall dimensions.

How often should chain tension be checked on a machine in operation?

In machines operating continuously, it is advisable to check the tension every few weeks, and in a newly installed drive - as early as after the first hours of operation, when the chain "beds in". A correctly tensioned chain has a slight, visible sag on the slack side - too tight a chain accelerates bearing wear, while too loose a chain increases the risk of it jumping off the sprocket.

When should I choose a sprocket with hub and when a flat one (plate wheel)?

Flat sprockets (plate wheels) are most often used where they are mounted onto an existing flange or drum, or when there is extremely little space on the shaft. We choose a sprocket with hub when it must reliably transmit high torque directly from the shaft via a key - the hub provides a longer contact surface.

Where is this product used?

This type of sprocket is used in drives of agricultural and industrial machinery, including screw and bucket conveyors, feed conveyors, packaging machines and internal transport systems.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.