Sprocket 16B-3 z=29 with hub

Product Description

Sprocket 16B-3 z=29, with hub

Sprocket 16B-3, triplex (three-strand), with 29 teeth and a hub - pitch 1" (25.4 mm). Manufactured in accordance with DIN 8187 / ISO 606 from C45E structural steel (EN 10083-1), without tooth hardening - as a Polish manufacturer, Ozdowski supplies an economical version that is fully dimensionally interchangeable with the hardened variant of the same pitch.

Technical data

Frequently asked questions

Does a sprocket with hub have a fixed mounting side, or can it be reversed?

The sprocket is usually symmetrical with respect to the plane of the rim, so the rim itself cannot be "reversed incorrectly" - but the hub is usually on only one side of the sprocket, which determines which way the sprocket must be mounted relative to other components on the shaft (e.g. bearings, other sprockets).

Do I need to select dedicated bearings for a sprocket with hub?

A sprocket with hub mounted with a key does not require its own bearings - the load is carried by the bearings of the shaft on which the sprocket is mounted. A dedicated bearing built into the sprocket is only needed for tensioning or guide sprockets mounted on an axle without its own drive.

Does a larger number of teeth always mean a longer service life for the sprocket?

Largely yes - the more teeth are engaged, the lower the load on each individual tooth, and the chain runs over a larger wrap angle, which reduces dynamic impacts. Very small sprockets (with fewer than fifteen or so teeth) wear the fastest and are best avoided if the drive design allows.

Can a sprocket with a technological bore be installed without additional machining?

No - the technological bore is deliberately too small to fit a typical shaft. It must be bored on a lathe to the required diameter and, if necessary, a keyway cut according to the requirements of the specific machine.

Where is this product used?

This type of sprocket is used in drives of agricultural and industrial machinery, including screw and bucket conveyors, feed conveyors, packaging machines and internal transport systems.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.