Sprocket 16B-1 z=45 with hub, Cast iron

Product Description

Sprocket 16B-1 z=45, with cast iron hub

Sprocket 16B-1, simplex, with 45 teeth and a hub - pitch 1" (25.4 mm). The sprocket is made of grey cast iron - a traditional material for sprockets in applications with moderate loads and lower rotational speeds; the bore in the hub is a pilot bore intended to be machined to the shaft size.

Technical data

Frequently asked questions

What forces act on the key in a sprocket and how can it be prevented from shearing?

The key transmits the entire shearing torque between the shaft and the sprocket. Make sure it is made of suitable quenched and tempered steel, has an accurate fit in the keyway and that the machine is not subjected to extreme jerks without an overload clutch.

How do you correctly align sprockets during installation?

The driving and driven sprockets must be in one perfect line. You can use a long steel straightedge placed against the faces of both sprockets or a professional laser alignment tool. Even a slight angular deviation will quickly destroy the chain.

How often should chain tension be checked on a machine in operation?

In machines operating continuously, it is advisable to check the tension every few weeks, and in a newly installed drive - as early as after the first hours of operation, when the chain "beds in". A correctly tensioned chain has a slight, visible sag on the slack side - too tight a chain accelerates bearing wear, while too loose a chain increases the risk of it jumping off the sprocket.

How does rotational speed affect the selection of the minimum number of teeth of a sprocket in the system?

At higher rotational speeds, a larger minimum number of teeth on the smallest sprocket in the system is recommended to reduce chain vibration and impacts resulting from the so-called polygon effect. With very small sprockets (e.g. 9-11 teeth) and high speeds, wear and vibration levels increase significantly faster than with larger sprockets.

Does a cast iron sprocket require a different chain than a steel sprocket of the same pitch?

No - the tooth geometry and pitch are identical to those of the steel version of the same size, so the cast iron sprocket works with the same chain. The difference lies in the material of the hub and rim: cast iron dampens vibrations better and is cheaper, but withstands impacts and operation at high rotational speeds less well than steel.

Where is this product used?

16B-1 sprockets are used in industrial drive transmissions: conveyors, feeders, packaging machines and production lines where precise, repeatable torque transmission matters.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.