Sprocket 16B-1 z=44 with hub

Product Description

Sprocket 16B-1 z=44, with hub

Simplex sprocket 16B-1 with hub, 44 teeth - designed for chain with a pitch of 1" (25.4 mm). The material is C45E carbon steel (EN 10083-1), and the teeth remain unhardened (without induction hardening) - in accordance with DIN 8187 / ISO 606; this version is easier to machine over the entire depth of the sprocket.

Technical data

Frequently asked questions

How can you tell whether a sprocket is still fit for further service or already due for replacement?

It is worth checking the tooth profile for visible chipping or the characteristic "hooked" shape, and also measuring the pitch circle diameter and comparing it with the catalogue dimension of a new sprocket. If the difference is visually noticeable or the chain starts to "jump", the sprocket is due for replacement.

What does uneven, one-sided wear of the sprocket teeth indicate?

This usually indicates misalignment between the driving and driven sprockets or that the chain is skewed relative to the sprocket. It is worth checking the alignment of both sprockets and the condition of the shaft bearings - over time, one-sided wear causes the chain to jump off the tooth.

What should be used to preserve sprockets before a longer break in operation?

After cleaning with a brush and a technical cleaner, apply preservative grease or a thick, moisture-displacing spray oil to the entire surface of the sprocket. This will protect the metal against rust deposits during the break while it is stored in the hall.

What forces act on the key in a sprocket and how can it be prevented from shearing?

The key transmits the entire shearing torque between the shaft and the sprocket. Make sure it is made of suitable quenched and tempered steel, has an accurate fit in the keyway and that the machine is not subjected to extreme jerks without an overload clutch.

Where is this product used?

Typical applications of the 16B-1 sprocket: drives for pumps, mixers and industrial fans, as well as control systems for industrial gates and roller shutters, where resistance to continuous operation is required.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.