Sprocket 16B-1 z=38 with hub

Product Description

Sprocket 16B-1 z=38, with hub

Sprocket 16B-1, simplex, with 38 teeth and a hub - pitch 1" (25.4 mm). As a European manufacturer, Ozdowski supplies the sprocket in C45E steel (EN 10083-1), in accordance with DIN 8187 / ISO 606 - a version without tooth hardening, cheaper than the hardened variant and sufficient for many typical industrial applications.

Technical data

Frequently asked questions

How does rotational speed affect the selection of the minimum number of teeth of a sprocket in the system?

At higher rotational speeds, a larger minimum number of teeth on the smallest sprocket in the system is recommended to reduce chain vibration and impacts resulting from the so-called polygon effect. With very small sprockets (e.g. 9-11 teeth) and high speeds, wear and vibration levels increase significantly faster than with larger sprockets.

Can a sprocket with a technological bore be installed without additional machining?

No - the technological bore is deliberately too small to fit a typical shaft. It must be bored on a lathe to the required diameter and, if necessary, a keyway cut according to the requirements of the specific machine.

What causes premature wear of the side faces of the teeth?

This is most often the result of misalignment of the sprockets on the shafts (so-called lateral runout of the drive). The chain does not run straight, and its inner plates catch on the sides of the teeth, wearing them down to bare metal. The system must be realigned immediately.

What should be used to preserve sprockets before a longer break in operation?

After cleaning with a brush and a technical cleaner, apply preservative grease or a thick, moisture-displacing spray oil to the entire surface of the sprocket. This will protect the metal against rust deposits during the break while it is stored in the hall.

Where is this product used?

This type of sprocket is used in drives of agricultural and industrial machinery, including screw and bucket conveyors, feed conveyors, packaging machines and internal transport systems.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.