Sprocket 16B-1 z=32 with hub

Product Description

Sprocket 16B-1 z=32, with hub

The sprocket 16B-1 shown is a simplex sprocket with 32 teeth, made with a hub, for chain with a pitch of 1" / 25.4 mm. The sprocket complies with DIN 8187 / ISO 606 and is made of C45E steel (EN 10083-1); the teeth are not hardened, which lowers the cost of the sprocket and makes it easier to machine (e.g. deep boring of the hub) throughout the entire volume of the material.

Technical data

Frequently asked questions

Will a sprocket from another manufacturer work properly with the chain I already have?

If the sprocket is made to the same standard (DIN 8187/ISO 606) and has the same pitch and number of strands, it should work properly with a chain of another brand - that is the purpose of standardisation in this industry. However, differences between manufacturers may concern, for example, hub dimensions or material, so these parameters are worth checking separately.

How can a sprocket and chain be protected against corrosion during storage?

After cleaning off any dirt, it is advisable to apply a layer of preservative grease or anti-corrosion oil and store the sprocket in a dry place not exposed to condensation. In the steel version (without coating), even a short damp break in the workshop can cause a rusty film on the tooth surfaces.

What is the set screw hole in the hub for?

The threaded hole in the hub is used to screw in a headless screw (a so-called grub screw). It secures the sprocket against axial displacement along the shaft during machine vibration.

Does a larger number of teeth always mean a longer service life for the sprocket?

Largely yes - the more teeth are engaged, the lower the load on each individual tooth, and the chain runs over a larger wrap angle, which reduces dynamic impacts. Very small sprockets (with fewer than fifteen or so teeth) wear the fastest and are best avoided if the drive design allows.

Where is this product used?

16B-1 sprockets operate in drives of construction machinery, goods lifts, aggregate conveyors and woodworking machines - wherever tooth durability under load matters.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.