Sprocket 16B-1 z=31 with hub

Product Description

Sprocket 16B-1 z=31, with hub

The sprocket 16B-1 shown is a simplex sprocket with 31 teeth, made with a hub, for chain with a pitch of 1" / 25.4 mm. The sprocket complies with DIN 8187 / ISO 606 and is made of C45E steel (EN 10083-1); the teeth are not hardened, which lowers the cost of the sprocket and makes it easier to machine (e.g. deep boring of the hub) throughout the entire volume of the material.

Technical data

Frequently asked questions

How do I check the radial and axial runout of a sprocket after mounting it on the shaft?

A dial indicator on a magnetic stand is used for the measurement. Place the tip against the circumference of the sprocket or its side face, rotate the shaft and check the deviations. Excessive runout indicates faulty installation or a damaged shaft.

Can a sprocket be welded directly to the drive shaft?

Technically this is possible, but we strongly advise against such a solution. Welding overheats the material, damages nearby bearings, bends the shaft and prevents the worn sprocket from being easily replaced later. Always use mounting with a key or a clamping bush.

Does a larger number of teeth always mean a longer service life for the sprocket?

Largely yes - the more teeth are engaged, the lower the load on each individual tooth, and the chain runs over a larger wrap angle, which reduces dynamic impacts. Very small sprockets (with fewer than fifteen or so teeth) wear the fastest and are best avoided if the drive design allows.

Can a sprocket with a technological bore be installed without additional machining?

No - the technological bore is deliberately too small to fit a typical shaft. It must be bored on a lathe to the required diameter and, if necessary, a keyway cut according to the requirements of the specific machine.

Where is this product used?

Typical applications of the 16B-1 sprocket: drives for pumps, mixers and industrial fans, as well as control systems for industrial gates and roller shutters, where resistance to continuous operation is required.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.