Sprocket 12B-3 z=57 with hub, Cast iron

Product Description

Sprocket 12B-3 z=57, with cast iron hub

The sprocket 12B-3 shown is a triplex (three-strand) sprocket with 57 teeth, made with a hub, for chain with a pitch of 3/4" / 19.05 mm. Cast iron version of the sprocket - the tooth geometry is identical to the steel version with the same pitch and number of teeth; the bore in the hub is a pilot (preliminary) bore, and the exact size is achieved by turning.

Technical data

Frequently asked questions

How do you select a sprocket when the machine lacks space for a larger pitch?

In such a situation, a better solution than increasing the pitch is often to use a multi-strand chain and sprocket of the same (smaller) pitch - several strands together carry a greater load without increasing the sprocket diameter.

How do I bore the hole in a sprocket to fit a motor shaft?

A sprocket with a pilot bore should be clamped in a lathe (gripping the hub to avoid runout) and bored to the required diameter with an H7 tolerance. The hub is usually soft and easy to machine, even in the version with hardened teeth.

How long can a sprocket be kept in storage without losing its properties?

A properly preserved sprocket (dried, coated with grease or anti-corrosion oil, stored in a dry room) can be kept in storage for many years without any loss of its mechanical parameters. The only risk is surface corrosion due to improper storage - it does not affect the tooth geometry, but it is advisable to clean the sprocket and preserve it again before installation.

What does uneven, one-sided wear of the sprocket teeth indicate?

This usually indicates misalignment between the driving and driven sprockets or that the chain is skewed relative to the sprocket. It is worth checking the alignment of both sprockets and the condition of the shaft bearings - over time, one-sided wear causes the chain to jump off the tooth.

Does a cast iron sprocket require a different chain than a steel sprocket of the same pitch?

No - the tooth geometry and pitch are identical to those of the steel version of the same size, so the cast iron sprocket works with the same chain. The difference lies in the material of the hub and rim: cast iron dampens vibrations better and is cheaper, but withstands impacts and operation at high rotational speeds less well than steel.

Where is this product used?

This type of sprocket is used in drives of agricultural and industrial machinery, including screw and bucket conveyors, feed conveyors, packaging machines and internal transport systems.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.