Sprocket 12B-3 z=22 with hub

Product Description

Sprocket 12B-3 z=22, with hub

Triplex (three-strand) sprocket 12B-3 with hub, 22 teeth - designed for chain with a pitch of 3/4" (19.05 mm). The material is C45E carbon steel (EN 10083-1), and the teeth remain unhardened (without induction hardening) - in accordance with DIN 8187 / ISO 606; this version is easier to machine over the entire depth of the sprocket.

Technical data

Frequently asked questions

Can a sprocket with a technological bore be installed without additional machining?

No - the technological bore is deliberately too small to fit a typical shaft. It must be bored on a lathe to the required diameter and, if necessary, a keyway cut according to the requirements of the specific machine.

How can you recognise an idler sprocket bearing that is starting to wear before it fails?

The first symptom is usually increased noise and noticeable, excessive play of the sprocket when it is moved by hand with the machine stopped. It is also worth periodically checking the temperature of the bearing housing during operation - an increase compared with other bearings in the system signals progressive wear.

Can a new chain be fitted on an old, worn sprocket?

Never do this. An old, deformed sprocket has altered tooth geometry and will force drastic mechanical stretching on the new chain. The rule is "new chain - new sprocket" - only then will the drive achieve maximum service life.

Can a sprocket be reconditioned, e.g. by hardfacing worn teeth?

Technically, hardfacing and re-milling the teeth is possible, but in practice it is rarely cost-effective - the cost of reconditioning is often close to the price of a new sprocket, and restoring the full precision of the tooth profile requires specialist machining. In most cases, replacing it with a new sprocket is the quicker and safer solution.

Where is this product used?

Typical applications of the 12B-3 sprocket: drives for pumps, mixers and industrial fans, as well as control systems for industrial gates and roller shutters, where resistance to continuous operation is required.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.