Sprocket 12B-2 z=40 with hub, hardened

Product Description

Sprocket 12B-2 z=40, hardened hub

Duplex sprocket 12B-2 with hardened hub, 40 teeth - dedicated to a chain with a pitch of 3/4" (19.05 mm). As a European manufacturer, Ozdowski supplies the sprocket in C45E steel (EN 10083-1), in accordance with DIN 8187 / ISO 606 - the teeth are induction hardened (45-55 HRC), while the hub remains soft and easy to machine.

Technical data

Frequently asked questions

What is the set screw hole in the hub for?

The threaded hole in the hub is used to screw in a headless screw (a so-called grub screw). It secures the sprocket against axial displacement along the shaft during machine vibration.

How does uneven tooth wear affect machine vibration?

Worn teeth cause the so-called polygon effect - the chain drops off and climbs onto the teeth abruptly, which transmits vibrations to the shafts, destroys the bearings and leads to cracking of welds in the machine.

Can a sprocket with a technological bore be installed without additional machining?

No - the technological bore is deliberately too small to fit a typical shaft. It must be bored on a lathe to the required diameter and, if necessary, a keyway cut according to the requirements of the specific machine.

Is a duplex sprocket the same as a tandem sprocket (for two single chains)?

No, even though they look very similar. A tandem sprocket is also a single, monolithic sprocket, but with a different (wider) spacing of the toothed rims - designed specifically for two independent simplex chains running in parallel. This duplex sprocket has a rim spacing matched to a single duplex chain, in which both strands are integrated with each other. Using a duplex sprocket for two single chains is a mistake - the spacing is too narrow and the chains will rub against each other, which leads to accelerated wear and, in extreme cases, to serious drive failure.

Where is this product used?

Typical applications of the 12B-2 sprocket: drives for pumps, mixers and industrial fans, as well as control systems for industrial gates and roller shutters, where resistance to continuous operation is required.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.