Sprocket 12B-1 z=9 with hub

Product Description

Sprocket 12B-1 z=9, with hub

Simplex sprocket 12B-1 with hub, 9 teeth - designed for chain with a pitch of 3/4" (19.05 mm). Manufactured in accordance with DIN 8187 / ISO 606 from C45E structural steel (EN 10083-1), without tooth hardening - as a Polish manufacturer, Ozdowski supplies an economical version that is fully dimensionally interchangeable with the hardened variant of the same pitch.

Technical data

Frequently asked questions

What does uneven, one-sided wear of the sprocket teeth indicate?

This usually indicates misalignment between the driving and driven sprockets or that the chain is skewed relative to the sprocket. It is worth checking the alignment of both sprockets and the condition of the shaft bearings - over time, one-sided wear causes the chain to jump off the tooth.

What should be used to preserve sprockets before a longer break in operation?

After cleaning with a brush and a technical cleaner, apply preservative grease or a thick, moisture-displacing spray oil to the entire surface of the sprocket. This will protect the metal against rust deposits during the break while it is stored in the hall.

How often should chain tension be checked on a machine in operation?

In machines operating continuously, it is advisable to check the tension every few weeks, and in a newly installed drive - as early as after the first hours of operation, when the chain "beds in". A correctly tensioned chain has a slight, visible sag on the slack side - too tight a chain accelerates bearing wear, while too loose a chain increases the risk of it jumping off the sprocket.

How can you check that the sprocket meshes correctly with the chain when the machine is started for the first time?

At low speed (e.g. turning the shaft by hand), it is worth observing whether the chain enters and leaves the teeth smoothly around the entire circumference of the sprocket, without catching or jumping. Any irregularities in operation at this stage usually indicate an alignment error rather than a defect in the sprocket itself.

Where is this product used?

12B-1 sprockets operate in drives of construction machinery, goods lifts, aggregate conveyors and woodworking machines - wherever tooth durability under load matters.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.