Sprocket 12B-1 z=62 with hub

Product Description

Sprocket 12B-1 z=62, with hub

Simplex sprocket 12B-1 with hub, 62 teeth - designed for chain with a pitch of 3/4" (19.05 mm). Manufactured in accordance with DIN 8187 / ISO 606 from C45E structural steel (EN 10083-1), without tooth hardening - as a Polish manufacturer, Ozdowski supplies an economical version that is fully dimensionally interchangeable with the hardened variant of the same pitch.

Technical data

Frequently asked questions

How do I select a sprocket with bearing for a tensioning system?

An idler sprocket (with built-in bearing) is selected according to the pitch of the working chain and mounted on the slack side (not on the tight side). It is important that the bearing is protected against dust, especially in agricultural machinery.

What should be used to preserve sprockets before a longer break in operation?

After cleaning with a brush and a technical cleaner, apply preservative grease or a thick, moisture-displacing spray oil to the entire surface of the sprocket. This will protect the metal against rust deposits during the break while it is stored in the hall.

Can a sprocket with a technological bore be installed without additional machining?

No - the technological bore is deliberately too small to fit a typical shaft. It must be bored on a lathe to the required diameter and, if necessary, a keyway cut according to the requirements of the specific machine.

How long can a sprocket be kept in storage without losing its properties?

A properly preserved sprocket (dried, coated with grease or anti-corrosion oil, stored in a dry room) can be kept in storage for many years without any loss of its mechanical parameters. The only risk is surface corrosion due to improper storage - it does not affect the tooth geometry, but it is advisable to clean the sprocket and preserve it again before installation.

Where is this product used?

Typical applications of the 12B-1 sprocket: drives for pumps, mixers and industrial fans, as well as control systems for industrial gates and roller shutters, where resistance to continuous operation is required.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.