Sprocket 10B-3 z=95 with hub

Product Description

Sprocket 10B-3 z=95, with hub

Triplex (three-strand) sprocket 10B-3 with hub, 95 teeth - designed for chain with a pitch of 5/8" (15.88 mm). As a European manufacturer, Ozdowski supplies the sprocket in C45E steel (EN 10083-1), in accordance with DIN 8187 / ISO 606 - a version without tooth hardening, cheaper than the hardened variant and sufficient for many typical industrial applications.

Technical data

Frequently asked questions

How can you recognise a sprocket not made in accordance with the DIN 8187 profile?

Most often it is visible from the incorrect seating of the chain on the teeth - the chain "sits" on the tooth tips or too deep in the tooth roots, despite the correct pitch. In that case, it is worth placing a section of a known reference chain of this pitch on the sprocket and checking whether it engages each tooth evenly and smoothly.

How does one duplex sprocket differ from two independent simplex sprockets on a common shaft?

A duplex sprocket is a single, monolithic toothed rim serving a duplex chain, in which both strands are mechanically integrated in one component. Two independent simplex sprockets on a common shaft serve two completely separate simplex chains - these solutions are not interchangeable without changing the chain type.

How does rotational speed affect the selection of the minimum number of teeth of a sprocket in the system?

At higher rotational speeds, a larger minimum number of teeth on the smallest sprocket in the system is recommended to reduce chain vibration and impacts resulting from the so-called polygon effect. With very small sprockets (e.g. 9-11 teeth) and high speeds, wear and vibration levels increase significantly faster than with larger sprockets.

Do I need to select dedicated bearings for a sprocket with hub?

A sprocket with hub mounted with a key does not require its own bearings - the load is carried by the bearings of the shaft on which the sprocket is mounted. A dedicated bearing built into the sprocket is only needed for tensioning or guide sprockets mounted on an axle without its own drive.

Where is this product used?

10B-3 sprockets are used in industrial drive transmissions: conveyors, feeders, packaging machines and production lines where precise, repeatable torque transmission matters.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.