Sprocket 10B-3 z=33 with hub

Product Description

Sprocket 10B-3 z=33, with hub

Sprocket 10B-3 with hub, 33 teeth, triplex (three-strand) - a product matched to chain with a pitch of 15.88 mm (5/8"). The sprocket complies with DIN 8187 / ISO 606 and is made of C45E steel (EN 10083-1); the teeth are not hardened, which lowers the cost of the sprocket and makes it easier to machine (e.g. deep boring of the hub) throughout the entire volume of the material.

Technical data

Frequently asked questions

Can a sprocket with a technological bore be installed without additional machining?

No - the technological bore is deliberately too small to fit a typical shaft. It must be bored on a lathe to the required diameter and, if necessary, a keyway cut according to the requirements of the specific machine.

Do I need to select dedicated bearings for a sprocket with hub?

A sprocket with hub mounted with a key does not require its own bearings - the load is carried by the bearings of the shaft on which the sprocket is mounted. A dedicated bearing built into the sprocket is only needed for tensioning or guide sprockets mounted on an axle without its own drive.

How can you check whether the chain in an existing drive is already excessively elongated (stretched)?

Stretch out a section of a dozen or so chain links and compare its length with the catalogue dimension - an elongation of more than approx. 2-3% means the chain is due for replacement. A stretched chain no longer seats properly on the sprocket teeth, which accelerates the wear of both components, so it is better to replace it before it damages the sprocket as well.

Do a newly fitted chain and sprocket require running-in after installation?

After installation, it is worth running the drive for a while without full load, observing the smoothness of operation and the bearing temperature - this allows installation errors (e.g. misalignment) to be detected before full load is applied. The tooth profile of the sprocket itself does not require running-in if the sprocket and chain have matching pitch and are made in accordance with the standard.

Where is this product used?

Typical applications of the 10B-3 sprocket: drives for pumps, mixers and industrial fans, as well as control systems for industrial gates and roller shutters, where resistance to continuous operation is required.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.