Sprocket 10B-2 z=8 with hub, hardened

Product Description

Sprocket 10B-2 z=8, hardened hub

Sprocket 10B-2 (pitch 5/8" - 15.875 mm), duplex, 8 teeth, with hardened hub. Sprocket compliant with DIN 8187 / ISO 606, milled from C45E steel (EN 10083-1); the teeth are induction hardened (45-55 HRC), while the core and hub remain soft, allowing the bore to be safely machined to the shaft size.

Technical data

Frequently asked questions

What should be used to preserve sprockets before a longer break in operation?

After cleaning with a brush and a technical cleaner, apply preservative grease or a thick, moisture-displacing spray oil to the entire surface of the sprocket. This will protect the carbon steel against a rusty film during a break in the workshop.

How do you cut a keyway in the hub of a sprocket?

We cut keyways precisely on slotting machines according to DIN 6885. If you do it yourself, maintain axial alignment and the correct width and depth of the keyway so that the key sits securely and is not sheared off.

Can a new chain be fitted on an old, worn sprocket?

Never do this. An old, deformed sprocket has altered tooth geometry and will force drastic mechanical stretching on the new chain. The rule is "new chain - new sprocket" - only then will the drive achieve maximum service life.

Is a duplex sprocket the same as a tandem sprocket (for two single chains)?

No, even though they look very similar. A tandem sprocket is also a single, monolithic sprocket, but with a different (wider) spacing of the toothed rims - designed specifically for two independent simplex chains running in parallel. This duplex sprocket has a rim spacing matched to a single duplex chain, in which both strands are integrated with each other. Using a duplex sprocket for two single chains is a mistake - the spacing is too narrow and the chains will rub against each other, which leads to accelerated wear and, in extreme cases, to serious drive failure.

Where is this product used?

This type of sprocket is used in drives of agricultural and industrial machinery, including screw and bucket conveyors, feed conveyors, packaging machines and internal transport systems.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.