Sprocket 10B-1 z=37 with hub

Product Description

Sprocket 10B-1 z=37, with hub

Sprocket 10B-1 with hub, 37 teeth, simplex - a product matched to chain with a pitch of 15.88 mm (5/8"). The sprocket complies with DIN 8187 / ISO 606 and is made of C45E steel (EN 10083-1); the teeth are not hardened, which lowers the cost of the sprocket and makes it easier to machine (e.g. deep boring of the hub) throughout the entire volume of the material.

Technical data

Frequently asked questions

Can I replace a simplex sprocket with a duplex one without changing the other drive components?

No - switching to a duplex chain and sprocket requires replacing the entire set (the sprockets on both sides of the drive and the chain) with a duplex version of the same pitch, because the rim spacing and chain width differ from those of the simplex version.

Does a sprocket with hub have a fixed mounting side, or can it be reversed?

The sprocket is usually symmetrical with respect to the plane of the rim, so the rim itself cannot be "reversed incorrectly" - but the hub is usually on only one side of the sprocket, which determines which way the sprocket must be mounted relative to other components on the shaft (e.g. bearings, other sprockets).

Does the machine's operating temperature matter when choosing the sprocket material?

Yes - at very low or very high temperatures the mechanical properties of steel or cast iron change, and lubricants may change viscosity or thicken. Under unusual thermal conditions (cold stores, furnaces, dryers), it is advisable to consult the supplier before selecting a specific material variant.

When is it worth using a clamping bush (Taper Bush) for a sprocket?

Wherever fast assembly matters. A clamping bush eliminates the need for laborious boring of the hub and cutting of a keyway - you insert the sprocket, tighten the screws and the machine is back in operation within minutes.

Where is this product used?

10B-1 sprockets are used in industrial drive transmissions: conveyors, feeders, packaging machines and production lines where precise, repeatable torque transmission matters.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.