Sprocket 10B-1 z=35 with hub

Product Description

Sprocket 10B-1 z=35, with hub

Sprocket 10B-1, simplex, with 35 teeth and a hub - pitch 5/8" (15.88 mm). Manufactured in accordance with DIN 8187 / ISO 606 from C45E structural steel (EN 10083-1), without tooth hardening - as a Polish manufacturer, Ozdowski supplies an economical version that is fully dimensionally interchangeable with the hardened variant of the same pitch.

Technical data

Frequently asked questions

How do I determine the centre distance between the driving and driven sprockets?

The centre distance should provide an adequate chain wrap angle on the smaller sprocket (usually a minimum of about 120°) and sufficient chain length so that the number of links is a whole number, preferably even. Too small a centre distance increases the meshing frequency and accelerates wear, while too large a one leads to excessive chain sag.

Why are cast sprockets less precise than turned and milled ones?

Cheap castings have a rough tooth surface, hidden air bubbles and slight deformations. CNC-turned and milled sprockets mean a smooth working surface, perfect alignment and safety for the most expensive machines.

How does the choice of the number of teeth affect vibration levels and drive operation?

A smaller number of teeth means fewer meshing points per revolution and larger fluctuations in the instantaneous chain speed (the so-called polygon effect), which results in higher vibration levels. Increasing the number of teeth of the sprocket (at the same pitch) smooths the operation of the drive, although it increases its overall dimensions.

Can a sprocket be welded directly to the drive shaft?

Technically this is possible, but we strongly advise against such a solution. Welding overheats the material, damages nearby bearings, bends the shaft and prevents the worn sprocket from being easily replaced later. Always use mounting with a key or a clamping bush.

Where is this product used?

Typical applications of the 10B-1 sprocket: drives for pumps, mixers and industrial fans, as well as control systems for industrial gates and roller shutters, where resistance to continuous operation is required.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.