Sprocket 08B-3 z=95 with hub

Product Description

Sprocket 08B-3 z=95, with hub

Sprocket 08B-3, triplex (three-strand), with 95 teeth and a hub - pitch 1/2" (12.7 mm). Manufactured in accordance with DIN 8187 / ISO 606 from C45E structural steel (EN 10083-1), without tooth hardening - as a Polish manufacturer, Ozdowski supplies an economical version that is fully dimensionally interchangeable with the hardened variant of the same pitch.

Technical data

Frequently asked questions

How should a chain drive be lubricated to extend its service life?

The lubricant should get between the rollers and plates of the chain, not just onto its outer surface - it is best applied to the lower (slack) part of the chain, just before it runs onto the sprocket. In a dusty environment, a thick grease works better, while at high speeds a lower-viscosity oil that penetrates the joints more easily is preferable.

Can I replace a simplex sprocket with a duplex one without changing the other drive components?

No - switching to a duplex chain and sprocket requires replacing the entire set (the sprockets on both sides of the drive and the chain) with a duplex version of the same pitch, because the rim spacing and chain width differ from those of the simplex version.

How do I check the radial and axial runout of a sprocket after mounting it on the shaft?

A dial indicator on a magnetic stand is used for the measurement. Place the tip against the circumference of the sprocket or its side face, rotate the shaft and check the deviations. Excessive runout indicates faulty installation or a damaged shaft.

Can a sprocket with a technological bore be installed without additional machining?

No - the technological bore is deliberately too small to fit a typical shaft. It must be bored on a lathe to the required diameter and, if necessary, a keyway cut according to the requirements of the specific machine.

Where is this product used?

Typical applications of the 08B-3 sprocket: drives for pumps, mixers and industrial fans, as well as control systems for industrial gates and roller shutters, where resistance to continuous operation is required.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.