Sprocket 08B-3 z=45 with hub

Product Description

Sprocket 08B-3 z=45, with hub

Sprocket 08B-3, triplex (three-strand), with 45 teeth and a hub - pitch 1/2" (12.7 mm). The material is C45E carbon steel (EN 10083-1), and the teeth remain unhardened (without induction hardening) - in accordance with DIN 8187 / ISO 606; this version is easier to machine over the entire depth of the sprocket.

Technical data

Frequently asked questions

How do I select a sprocket with bearing for a tensioning system?

An idler sprocket (with built-in bearing) is selected according to the pitch of the working chain and mounted on the slack side (not on the tight side). It is important that the bearing is protected against dust, especially in agricultural machinery.

How can you recognise a sprocket not made in accordance with the DIN 8187 profile?

Most often it is visible from the incorrect seating of the chain on the teeth - the chain "sits" on the tooth tips or too deep in the tooth roots, despite the correct pitch. In that case, it is worth placing a section of a known reference chain of this pitch on the sprocket and checking whether it engages each tooth evenly and smoothly.

How do I determine the centre distance between the driving and driven sprockets?

The centre distance should provide an adequate chain wrap angle on the smaller sprocket (usually a minimum of about 120°) and sufficient chain length so that the number of links is a whole number, preferably even. Too small a centre distance increases the meshing frequency and accelerates wear, while too large a one leads to excessive chain sag.

How does the choice of the number of teeth affect vibration levels and drive operation?

A smaller number of teeth means fewer meshing points per revolution and larger fluctuations in the instantaneous chain speed (the so-called polygon effect), which results in higher vibration levels. Increasing the number of teeth of the sprocket (at the same pitch) smooths the operation of the drive, although it increases its overall dimensions.

Where is this product used?

08B-3 sprockets are used in industrial drive transmissions: conveyors, feeders, packaging machines and production lines where precise, repeatable torque transmission matters.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.