Sprocket 08B-3 z=114 with hub, Cast iron

Product Description

Sprocket 08B-3 z=114, with cast iron hub

Triplex (three-strand) sprocket 08B-3 with hub, 114 teeth - designed for chain with a pitch of 1/2" (12.7 mm). The sprocket is made of grey cast iron - a traditional material for sprockets in applications with moderate loads and lower rotational speeds; the bore in the hub is a pilot bore intended to be machined to the shaft size.

Technical data

Frequently asked questions

Do a newly fitted chain and sprocket require running-in after installation?

After installation, it is worth running the drive for a while without full load, observing the smoothness of operation and the bearing temperature - this allows installation errors (e.g. misalignment) to be detected before full load is applied. The tooth profile of the sprocket itself does not require running-in if the sprocket and chain have matching pitch and are made in accordance with the standard.

What does the pitch of a sprocket mean and how can it be checked?

The pitch of a sprocket corresponds to the chain pitch - it is the theoretical distance between the centres of adjacent teeth on the pitch circle. The easiest way to check it is to place a section of matching chain on the sprocket - it should sit perfectly, without tension.

What forces act on the key in a sprocket and how can it be prevented from shearing?

The key transmits the entire shearing torque between the shaft and the sprocket. Make sure it is made of suitable quenched and tempered steel, has an accurate fit in the keyway and that the machine is not subjected to extreme jerks without an overload clutch.

How can you recognise an idler sprocket bearing that is starting to wear before it fails?

The first symptom is usually increased noise and noticeable, excessive play of the sprocket when it is moved by hand with the machine stopped. It is also worth periodically checking the temperature of the bearing housing during operation - an increase compared with other bearings in the system signals progressive wear.

Does a cast iron sprocket require a different chain than a steel sprocket of the same pitch?

No - the tooth geometry and pitch are identical to those of the steel version of the same size, so the cast iron sprocket works with the same chain. The difference lies in the material of the hub and rim: cast iron dampens vibrations better and is cheaper, but withstands impacts and operation at high rotational speeds less well than steel.

Where is this product used?

This type of sprocket is used in drives of agricultural and industrial machinery, including screw and bucket conveyors, feed conveyors, packaging machines and internal transport systems.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.