Sprocket 08B-1 z=76 with hub

Product Description

Sprocket 08B-1 z=76, with hub

Simplex sprocket 08B-1 with hub, 76 teeth - designed for chain with a pitch of 1/2" (12.7 mm). As a European manufacturer, Ozdowski supplies the sprocket in C45E steel (EN 10083-1), in accordance with DIN 8187 / ISO 606 - a version without tooth hardening, cheaper than the hardened variant and sufficient for many typical industrial applications.

Technical data

Frequently asked questions

How can a sprocket and chain be protected against corrosion during storage?

After cleaning off any dirt, it is advisable to apply a layer of preservative grease or anti-corrosion oil and store the sprocket in a dry place not exposed to condensation. In the steel version (without coating), even a short damp break in the workshop can cause a rusty film on the tooth surfaces.

How should a chain drive be lubricated to extend its service life?

The lubricant should get between the rollers and plates of the chain, not just onto its outer surface - it is best applied to the lower (slack) part of the chain, just before it runs onto the sprocket. In a dusty environment, a thick grease works better, while at high speeds a lower-viscosity oil that penetrates the joints more easily is preferable.

How can you check whether the chain in an existing drive is already excessively elongated (stretched)?

Stretch out a section of a dozen or so chain links and compare its length with the catalogue dimension - an elongation of more than approx. 2-3% means the chain is due for replacement. A stretched chain no longer seats properly on the sprocket teeth, which accelerates the wear of both components, so it is better to replace it before it damages the sprocket as well.

How do you select the number of teeth on the driving and driven sprockets to obtain the required ratio?

The ratio is calculated as the quotient of the number of teeth on the driven sprocket and the number of teeth on the driving sprocket. For example, to halve the rotational speed, the driven sprocket should have twice as many teeth as the driving sprocket - both sprockets must have the same pitch and number of strands.

Where is this product used?

08B-1 sprockets are used in industrial drive transmissions: conveyors, feeders, packaging machines and production lines where precise, repeatable torque transmission matters.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.