Sprocket 06B-3 z=8 with hub

Product Description

Sprocket 06B-3 z=8, with hub

Sprocket 06B-3 (pitch 3/8" - 9.53 mm), triplex (three-strand), 8 teeth, with hub. The sprocket complies with DIN 8187 / ISO 606 and is made of C45E steel (EN 10083-1); the teeth are not hardened, which lowers the cost of the sprocket and makes it easier to machine (e.g. deep boring of the hub) throughout the entire volume of the material.

Technical data

Frequently asked questions

Does a larger number of teeth always mean a longer service life for the sprocket?

Largely yes - the more teeth are engaged, the lower the load on each individual tooth, and the chain runs over a larger wrap angle, which reduces dynamic impacts. Very small sprockets (with fewer than fifteen or so teeth) wear the fastest and are best avoided if the drive design allows.

How can you check that the sprocket meshes correctly with the chain when the machine is started for the first time?

At low speed (e.g. turning the shaft by hand), it is worth observing whether the chain enters and leaves the teeth smoothly around the entire circumference of the sprocket, without catching or jumping. Any irregularities in operation at this stage usually indicate an alignment error rather than a defect in the sprocket itself.

How do you cut a keyway in the hub of a sprocket?

We cut keyways precisely on slotting machines according to DIN 6885. If you do it yourself, maintain axial alignment and the correct width and depth of the keyway so that the key sits securely and is not sheared off.

What does the pitch of a sprocket mean and how can it be checked?

The pitch of a sprocket corresponds to the chain pitch - it is the theoretical distance between the centres of adjacent teeth on the pitch circle. The easiest way to check it is to place a section of matching chain on the sprocket - it should sit perfectly, without tension.

Where is this product used?

Typical applications of the 06B-3 sprocket: drives for pumps, mixers and industrial fans, as well as control systems for industrial gates and roller shutters, where resistance to continuous operation is required.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.