Sprocket 06B-3 z=24 with hub

Product Description

Sprocket 06B-3 z=24, with hub

Sprocket 06B-3 with hub, 24 teeth, triplex (three-strand) - a product matched to chain with a pitch of 9.53 mm (3/8"). The sprocket complies with DIN 8187 / ISO 606 and is made of C45E steel (EN 10083-1); the teeth are not hardened, which lowers the cost of the sprocket and makes it easier to machine (e.g. deep boring of the hub) throughout the entire volume of the material.

Technical data

Frequently asked questions

Does a larger number of teeth always mean a longer service life for the sprocket?

Largely yes - the more teeth are engaged, the lower the load on each individual tooth, and the chain runs over a larger wrap angle, which reduces dynamic impacts. Very small sprockets (with fewer than fifteen or so teeth) wear the fastest and are best avoided if the drive design allows.

How does one duplex sprocket differ from two independent simplex sprockets on a common shaft?

A duplex sprocket is a single, monolithic toothed rim serving a duplex chain, in which both strands are mechanically integrated in one component. Two independent simplex sprockets on a common shaft serve two completely separate simplex chains - these solutions are not interchangeable without changing the chain type.

Does the machine's operating temperature matter when choosing the sprocket material?

Yes - at very low or very high temperatures the mechanical properties of steel or cast iron change, and lubricants may change viscosity or thicken. Under unusual thermal conditions (cold stores, furnaces, dryers), it is advisable to consult the supplier before selecting a specific material variant.

Is it possible to order a single trial piece of the sprocket before placing a larger order?

Yes, catalogue items can be ordered in any quantity, including a single piece for testing or verification before a larger series order.

Where is this product used?

Typical applications of the 06B-3 sprocket: drives for pumps, mixers and industrial fans, as well as control systems for industrial gates and roller shutters, where resistance to continuous operation is required.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.