Sprocket 06B-3 z=22 with hub

Product Description

Sprocket 06B-3 z=22, with hub

Sprocket 06B-3 (pitch 3/8" - 9.53 mm), triplex (three-strand), 22 teeth, with hub. The sprocket complies with DIN 8187 / ISO 606 and is made of C45E steel (EN 10083-1); the teeth are not hardened, which lowers the cost of the sprocket and makes it easier to machine (e.g. deep boring of the hub) throughout the entire volume of the material.

Technical data

Frequently asked questions

How long can a sprocket be kept in storage without losing its properties?

A properly preserved sprocket (dried, coated with grease or anti-corrosion oil, stored in a dry room) can be kept in storage for many years without any loss of its mechanical parameters. The only risk is surface corrosion due to improper storage - it does not affect the tooth geometry, but it is advisable to clean the sprocket and preserve it again before installation.

What forces act on the key in a sprocket and how can it be prevented from shearing?

The key transmits the entire shearing torque between the shaft and the sprocket. Make sure it is made of suitable quenched and tempered steel, has an accurate fit in the keyway and that the machine is not subjected to extreme jerks without an overload clutch.

Can a sprocket be welded directly to the drive shaft?

Technically this is possible, but we strongly advise against such a solution. Welding overheats the material, damages nearby bearings, bends the shaft and prevents the worn sprocket from being easily replaced later. Always use mounting with a key or a clamping bush.

Does a larger number of teeth always mean a longer service life for the sprocket?

Largely yes - the more teeth are engaged, the lower the load on each individual tooth, and the chain runs over a larger wrap angle, which reduces dynamic impacts. Very small sprockets (with fewer than fifteen or so teeth) wear the fastest and are best avoided if the drive design allows.

Where is this product used?

This type of sprocket is used in drives of agricultural and industrial machinery, including screw and bucket conveyors, feed conveyors, packaging machines and internal transport systems.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.