Sprocket 06B-2 z=45 with hub, Cast iron

Product Description

Sprocket 06B-2 z=45, with cast iron hub

Duplex sprocket 06B-2 with hub, 45 teeth - designed for chain with a pitch of 3/8" (9.53 mm). Cast iron version of the sprocket - the tooth geometry is identical to the steel version with the same pitch and number of teeth; the bore in the hub is a pilot (preliminary) bore, and the exact size is achieved by turning.

Technical data

Frequently asked questions

How does uneven tooth wear affect machine vibration?

Worn teeth cause the so-called polygon effect - the chain drops off and climbs onto the teeth abruptly, which transmits vibrations to the shafts, destroys the bearings and leads to cracking of welds in the machine.

What is the standard procedure for submitting a complaint about a sprocket?

It is advisable to contact customer service, providing the product code, order number, and a description and photos of the observed defect - this makes it possible to quickly assess whether the complaint is justified and to propose further steps.

How do I bore the hole in a sprocket to fit a motor shaft?

A sprocket with a pilot bore should be clamped in a lathe (gripping the hub to avoid runout) and bored to the required diameter with an H7 tolerance. The hub is usually soft and easy to machine, even in the version with hardened teeth.

When is it worth considering a sprocket made of reinforced steel for heavy-duty operating conditions?

In heavy dust, with powerful jerks (e.g. in presses) and wherever a breakdown in the middle of the season is not an option, sprockets made of higher-strength quenching and tempering steel or a variant with hardened teeth are often a good solution - it is worth consulting the supplier in the case of unusual operating conditions.

Is a duplex sprocket the same as a tandem sprocket (for two single chains)?

No, even though they look very similar. A tandem sprocket is also a single, monolithic sprocket, but with a different (wider) spacing of the toothed rims - designed specifically for two independent simplex chains running in parallel. This duplex sprocket has a rim spacing matched to a single duplex chain, in which both strands are integrated with each other. Using a duplex sprocket for two single chains is a mistake - the spacing is too narrow and the chains will rub against each other, which leads to accelerated wear and, in extreme cases, to serious drive failure.

Does a cast iron sprocket require a different chain than a steel sprocket of the same pitch?

No - the tooth geometry and pitch are identical to those of the steel version of the same size, so the cast iron sprocket works with the same chain. The difference lies in the material of the hub and rim: cast iron dampens vibrations better and is cheaper, but withstands impacts and operation at high rotational speeds less well than steel.

Where is this product used?

06B-2 sprockets are used in industrial drive transmissions: conveyors, feeders, packaging machines and production lines where precise, repeatable torque transmission matters.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.