Timing belt pulley PolyChain GT PC 8M 12 z=80 for Taper-Lock bush 2012

Product Description

Timing belt pulley PolyChain GT PC 8M 12 z=80 for Taper-Lock bush 2012 - for HTD 8M / PolyChain GT belts with a pitch of 8 mm (HTD). Made of C45 steel with a profile optimised for Gates PolyChain GT polyurethane belts.

The Taper-Lock system eliminates the need to bore out the hub. The bush slides into the tapered seat of the pulley and, after the screws are tightened to a torque of approx. 50 Nm, it clamps onto the shaft without a press or special tools. Removal is just as simple - one screw inserted into the removal hole pushes the bush out without risk of damaging the shaft.

Used in machines requiring accurate motion transmission: industrial drives, heavy machinery, production lines.

When ordering, please check the lead time - it is shown directly next to the product's stock level.

Pulley PolyChain GT 8M 12 mm, z=80 - Taper-Lock seat 2012

FAQ

How do I choose the Taper-Lock bush number?

The bush number (2012) is assigned to the pulley and determines the size of the seat. You only choose the bore diameter of the bush to suit your shaft. The maximum bore for this pulley is 20 mm.

How do I remove a pulley with a Taper-Lock bush?

Unscrew the mounting screws and screw one of them into the removal hole in the bush - it acts as a puller and pushes the bush out of the seat without damaging the shaft, without a press or hammer.

What shaft tolerance do you recommend?

The recommended shaft tolerance is h9 or h11. The shaft should be smooth and clean - rust or burrs will hinder proper clamping and may cause the pulley to slip under load.

How do you choose a pulley for a toothed belt?

The key is matching the series (8M = 8 mm pitch (HTD)) and the belt width (12 mm). The drive ratio is calculated by dividing the number of teeth of the driven pulley by the number of teeth of the driving pulley.