Timing belt pulley 14M 170 z=192 for Taper-Lock bush 5050 Cast iron

Product Description

Timing belt pulley 14M 170 z=192 for Taper-Lock bush 5050 Cast iron - for HTD 14M belts with a pitch of 14 mm (HTD). Made of grey cast iron with a pearlitic structure.

The Taper-Lock system eliminates the need to bore out the hub. The bush slides into the tapered seat of the pulley and, after the screws are tightened to a torque of approx. 136 Nm, it clamps onto the shaft without a press or special tools. Removal is just as simple - one screw inserted into the removal hole pushes the bush out without risk of damaging the shaft.

Typical applications: heavy industrial drives, presses, agricultural and construction machinery.

When ordering, please check the lead time - it is shown directly next to the product's stock level.

Timing belt pulley 14M 170 mm, 192 teeth - Taper-Lock 5050

FAQ

How do I mount the pulley on a Taper-Lock bush?

The bush is inserted into the tapered seat of the pulley, placed on the shaft and the screws are tightened to a torque of approx. 136 Nm. The pulley is ready in a few minutes, without a press or special tools.

How do I choose the Taper-Lock bush number?

The bush number (5050) is assigned to the pulley and determines the size of the seat. You only choose the bore diameter of the bush to suit your shaft.

How do I remove a pulley with a Taper-Lock bush?

Unscrew the mounting screws and screw one of them into the removal hole in the bush - it acts as a puller and pushes the bush out of the seat without damaging the shaft, without a press or hammer.

What shaft tolerance do you recommend?

The recommended shaft tolerance is h9 or h11. The shaft should be smooth and clean - rust or burrs will hinder proper clamping and may cause the pulley to slip under load.