Spur gear module 2 z=34 with hub

Product Description

Spur gear module 2, z=34, with hub

This module 2 spur gear (34 teeth, with hub) is used wherever reliable, maintenance-free power transmission via involute gearing is required. Made of C45E steel (UNI/EN 10083-1), which ensures high mechanical strength and wear resistance during prolonged operation under load.

Technical data

Frequently asked questions

How should gears be stored correctly before installation?

Preferably in a dry room, protected against moisture and dust, with a light layer of preservative oil on the teeth and bore - especially important for C45E carbon steel, which can start to corrode without protection.

Do straight-tooth module gears have a specific mounting direction?

No, a straight-tooth gear is symmetrical and can be mounted either way round; direction only matters with helical teeth, where the helix angle must match the mating gear.

How do you set the correct centre distance between two module gears?

The centre distance is the sum of the pitch diameters of both gears divided by two (a = (Dp1+Dp2)/2); too small a distance causes seizing, and too large a distance - excessive backlash and loss of quiet running.

Can a module gear be painted or lacquered?

Yes, the external surfaces (sides, circumference) can be protected with lacquer, but the teeth and the mounting bore should remain clean, because the coating would change their actual dimensions and disrupt meshing with the other gear.

Where is this product used?

Used in the construction and servicing of gear reducers and gear transmissions for agricultural and construction machinery, and wherever precise and repeatable torque transmission matters.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.