Spur gear module 2 z=26 with hub

Product Description

Spur gear module 2, z=26, with hub

This module 2 spur gear (26 teeth, with hub) is used wherever reliable, maintenance-free power transmission via involute gearing is required. Made of C45E steel (UNI/EN 10083-1), which ensures high mechanical strength and wear resistance during prolonged operation under load.

Technical data

Frequently asked questions

How can wear of the gears in a module gearbox be diagnosed?

Wear is easiest to spot from a change in the tooth profile - it becomes sharp at the tip, and the backlash increases dramatically, which shows up as loud knocking when the machine changes its direction of rotation.

Does a higher number of teeth (z) with the same module mean a stronger gear?

Not directly - tooth strength depends mainly on the module and face width, not on the number of teeth; a larger z with the same module simply gives a larger gear diameter and a higher ratio relative to the mating gear.

How do you set the correct centre distance between two module gears?

The centre distance is the sum of the pitch diameters of both gears divided by two (a = (Dp1+Dp2)/2); too small a distance causes seizing, and too large a distance - excessive backlash and loss of quiet running.

Can module gears be bored out for non-standard shafts?

Yes, most module gears are supplied with a pilot bore, which allows them to be freely bored out, keyway-slotted and precisely fitted to the specific shaft size at the customer's premises.

Where is this product used?

Module gears of this type are used in speed reducers, machine gearboxes, CNC machine tools and in rack drives of sliding and entrance gates.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.