Spur gear module 1 z=47 with hub hardened

Product Description

Spur gear module 1, z=47, with hub, hardened

This module 1 spur gear (47 teeth, with hub) is used wherever reliable, maintenance-free power transmission via involute gearing is required. The tooth surface is induction hardened (45-55 HRC), so the gear better withstands high cyclic loads and operation in harsh industrial conditions.

Technical data

Frequently asked questions

How do you set the correct centre distance between two module gears?

The centre distance is the sum of the pitch diameters of both gears divided by two (a = (Dp1+Dp2)/2); too small a distance causes seizing, and too large a distance - excessive backlash and loss of quiet running.

Does a module gear require constant lubrication?

Enclosed gears (in speed reducers) run in oil or grease, while open systems (gear + rack) require periodic manual lubrication - without it, friction and tooth wear increase many times faster.

How do you measure a worn tooth to choose the right replacement?

It is best to measure the outside diameter (Dz) and count the teeth (Z), and calculate the module from the formula m = Dz / (Z+2); it is also worth measuring the bore diameter so that the replacement fits the same shaft without additional machining.

Can gears with different modules be combined in one gearbox?

Absolutely not. Teeth of different modules differ in size and pitch. Any attempt to mesh them will end in the drive jamming or the teeth breaking off immediately on the first revolution of the shaft.

Where is this product used?

Module gears of this type are used in speed reducers, machine gearboxes, CNC machine tools and in rack drives of sliding and entrance gates.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.