Sprocket 28B-1 z=38 with hub

Product Description

Sprocket 28B-1 z=38, with hub

Sprocket 28B-1 (pitch 1 3/4" - 44.45 mm), simplex, 38 teeth, with hub. Manufactured in accordance with DIN 8187 / ISO 606 from C45E structural steel (EN 10083-1), without tooth hardening - as a Polish manufacturer, Ozdowski supplies an economical version that is fully dimensionally interchangeable with the hardened variant of the same pitch.

Technical data

Frequently asked questions

How do I bore the hole in a sprocket to fit a motor shaft?

A sprocket with a pilot bore should be clamped in a lathe (gripping the hub to avoid runout) and bored to the required diameter with an H7 tolerance. The hub is usually soft and easy to machine, even in the version with hardened teeth.

Can a new chain be fitted on an old, worn sprocket?

Never do this. An old, deformed sprocket has altered tooth geometry and will force drastic mechanical stretching on the new chain. The rule is "new chain - new sprocket" - only then will the drive achieve maximum service life.

What is the relationship between the number of teeth of a sprocket and the rotational speed of the drive?

This is the basic principle of the transmission ratio. If there is a small sprocket on the motor (drive) and a large one on the machine, the machine will turn more slowly but gain proportionally greater torque (force).

How often should chain tension be checked on a machine in operation?

In machines operating continuously, it is advisable to check the tension every few weeks, and in a newly installed drive - as early as after the first hours of operation, when the chain "beds in". A correctly tensioned chain has a slight, visible sag on the slack side - too tight a chain accelerates bearing wear, while too loose a chain increases the risk of it jumping off the sprocket.

Where is this product used?

Typical applications of the 28B-1 sprocket: drives for pumps, mixers and industrial fans, as well as control systems for industrial gates and roller shutters, where resistance to continuous operation is required.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.