Sprocket 24B-1 z=26 with hub

Product Description

Sprocket 24B-1 z=26, with hub

Simplex sprocket 24B-1 with hub, 26 teeth - designed for chain with a pitch of 1 1/2" (38.1 mm). The sprocket complies with DIN 8187 / ISO 606 and is made of C45E steel (EN 10083-1); the teeth are not hardened, which lowers the cost of the sprocket and makes it easier to machine (e.g. deep boring of the hub) throughout the entire volume of the material.

Technical data

Frequently asked questions

How does a sprocket with hardened teeth differ from the standard version (non-hardened)?

The hardened version has teeth induction-hardened to 45-55 HRC, which extends service life in drives operating continuously and under heavy load. The standard version (non-hardened) is cheaper and fully adequate for applications with moderate load or intermittent operation - our catalogue offers both variants for most pitches and numbers of teeth.

Does a larger number of teeth always mean a longer service life for the sprocket?

Largely yes - the more teeth are engaged, the lower the load on each individual tooth, and the chain runs over a larger wrap angle, which reduces dynamic impacts. Very small sprockets (with fewer than fifteen or so teeth) wear the fastest and are best avoided if the drive design allows.

How long can a sprocket be kept in storage without losing its properties?

A properly preserved sprocket (dried, coated with grease or anti-corrosion oil, stored in a dry room) can be kept in storage for many years without any loss of its mechanical parameters. The only risk is surface corrosion due to improper storage - it does not affect the tooth geometry, but it is advisable to clean the sprocket and preserve it again before installation.

How should large-diameter sprockets be transported and stored to prevent deformation?

Large sprockets are best stored and transported lying flat on a level, stable surface, rather than resting on the toothed rim alone, which is more susceptible to local deformation. When lifting, it is advisable to use slings passed through the hub bore rather than hooking them onto individual teeth.

Where is this product used?

This type of sprocket is used in drives of agricultural and industrial machinery, including screw and bucket conveyors, feed conveyors, packaging machines and internal transport systems.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.