Sprocket 20B-2 z=15 with hub, hardened

Product Description

Sprocket 20B-2 z=15, hardened hub

The sprocket 20B-2 shown is a duplex sprocket with 15 teeth, made with a hardened hub, for chain with a pitch of 1 1/4" / 31.75 mm. The material is carbon steel C45E (EN 10083-1), and the teeth undergo induction hardening to 45-55 HRC - in accordance with DIN 8187 / ISO 606; the hub retains a lower core hardness, so it can be machined safely.

Technical data

Frequently asked questions

What causes premature wear of the side faces of the teeth?

This is most often the result of misalignment of the sprockets on the shafts (so-called lateral runout of the drive). The chain does not run straight, and its inner plates catch on the sides of the teeth, wearing them down to bare metal. The system must be realigned immediately.

How do I check the radial and axial runout of a sprocket after mounting it on the shaft?

A dial indicator on a magnetic stand is used for the measurement. Place the tip against the circumference of the sprocket or its side face, rotate the shaft and check the deviations. Excessive runout indicates faulty installation or a damaged shaft.

What is the relationship between the number of teeth of a sprocket and the rotational speed of the drive?

This is the basic principle of the transmission ratio. If there is a small sprocket on the motor (drive) and a large one on the machine, the machine will turn more slowly but gain proportionally greater torque (force).

Is a duplex sprocket the same as a tandem sprocket (for two single chains)?

No, even though they look very similar. A tandem sprocket is also a single, monolithic sprocket, but with a different (wider) spacing of the toothed rims - designed specifically for two independent simplex chains running in parallel. This duplex sprocket has a rim spacing matched to a single duplex chain, in which both strands are integrated with each other. Using a duplex sprocket for two single chains is a mistake - the spacing is too narrow and the chains will rub against each other, which leads to accelerated wear and, in extreme cases, to serious drive failure.

Where is this product used?

This type of sprocket is used in drives of agricultural and industrial machinery, including screw and bucket conveyors, feed conveyors, packaging machines and internal transport systems.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.