Sprocket 16B-2 z=11 with hub, hardened

Product Description

Sprocket 16B-2 z=11, hardened hub

Sprocket 16B-2, duplex, with 11 teeth and a hardened hub - pitch 1" (25.4 mm). The material is carbon steel C45E (EN 10083-1), and the teeth undergo induction hardening to 45-55 HRC - in accordance with DIN 8187 / ISO 606; the hub retains a lower core hardness, so it can be machined safely.

Technical data

Frequently asked questions

How does induction hardening of the teeth affect abrasion resistance?

Induction hardening hardens only the surface layer of the tooth, where the chain rollers bear. The tooth is resistant to wear, while the sprocket core and hub remain elastic enough to safely absorb impacts and be suitable for boring.

Can a new chain be fitted on an old, worn sprocket?

Never do this. An old, deformed sprocket has altered tooth geometry and will force drastic mechanical stretching on the new chain. The rule is "new chain - new sprocket" - only then will the drive achieve maximum service life.

How do I select a sprocket with bearing for a tensioning system?

An idler sprocket (with built-in bearing) is selected according to the pitch of the working chain and mounted on the slack side (not on the tight side). It is important that the bearing is protected against dust, especially in agricultural machinery.

Is a duplex sprocket the same as a tandem sprocket (for two single chains)?

No, even though they look very similar. A tandem sprocket is also a single, monolithic sprocket, but with a different (wider) spacing of the toothed rims - designed specifically for two independent simplex chains running in parallel. This duplex sprocket has a rim spacing matched to a single duplex chain, in which both strands are integrated with each other. Using a duplex sprocket for two single chains is a mistake - the spacing is too narrow and the chains will rub against each other, which leads to accelerated wear and, in extreme cases, to serious drive failure.

Where is this product used?

16B-2 sprockets operate in the drives of construction machinery, goods lifts, aggregate conveyors and woodworking machines - wherever tooth durability under heavy load matters.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.